Money Control SR3 - BANK 1 Programming; BANK 2 Programming

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 19 of 50
11.2 BANK 1
Table 6: Teach and Run™ Programming - Bank 1
Coin Number Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6
1
Off Off Off
ON ON
Off
2
Off Off
ON
Off
ON
Off
3
Off Off
ON ON ON
Off
4
Off
ON
Off Off
ON
Off
5
Off
ON
Off
ON ON
Off
6
Off
ON ON
Off
ON
Off
11.3 BANK 2
Table 7: Teach and Run™ Programming - Bank 2
Coin Number Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6
7
Off
ON ON ON ON
Off
8 ON
Off Off Off
ON
Off
9 ON
Off Off
ON ON
Off
10 ON
Off
ON
Off
ON
Off
11 ON
Off
ON ON ON
Off
12 ON ON
Off Off
ON
Off
Example:- To teach coin channel 12 for £1
Switch off the power to the SR3.
Set DIL switches to:-
MSB
SW1
SW2 SW3
LSB
SW4
Total SW5 SW6
ON ON
OFF OFF
12 ON
OFF
Switch on the power to the SR3.
Press the reject lever within 20 seconds.
The LED will turn RED.
Start entering £1 coins into the acceptor until the LED flashes GREEN, typically after 8 to 10
insertions.
Press the reject lever and the LED will turn RED then GREEN.
The coin channel has been programmed.
Set ALL switches to the OFF position.