HTP-1 Installation and User Guide Release 1.8.1
11. ETHERNET/SERVICE: An RJ45 jack for making a wired connection to an existing Ethernet
network. The USB port is for performing service at the factory.
12. ANTENNA: An SMA connector for attaching the included Bluetooth®/Wi-Fi® Antenna.
13. MAIN OUTPUTS: Sixteen balanced XLR jacks for connecting external power amplifiers. The
channel labels on the back panel are supplemented with a diagram labeled in the software for
complex speaker configurations.
14. GND: Screw terminal for making a ground connection to the chassis.
15. POWER SECTION: The POWER SECTION contains the Master Power Switch, the IEC Power
Connector for attaching the included AC Power Cord, and a Fuse Holder. Always disconnect the
power cord from the power source before replacing the fuse, and replace the fuse with the
same type. To assure a completely clean reboot, allow the HTP-1 to be powered down for 15
seconds before powering on again via the master power switch.
HTP-1 User Manual Page 13 V1.8.1
To Next Page
Loading...
