HTP-1 Installation and User Guide Release 1.8.1
render. The home page and front panel will replace their display of the HTP-1 volume setting to the
message “TV Audio." Also, all HTP-1 audio settings/status will be removed from these displays.
To get back to having the HTP-1 render audio, there are three options:
● Use the TV speaker settings to select the Amplifier to render audio. This will result in the TV
sending a command to the HTP-1 to turn on System Audio and informs the HTP-1 where to pick
up audio from.
● On the HTP-1 home page, below the “TV Audio” message is a button that has the text “CLICK TO
RETURN TO HTP-1 AUDIO." Pressing this will trigger the HTP-1 turn on System Audio.
● Selection of an audio only source, such as Coax, Optical, USB, etc. will trigger the HTP-1 to turn
on System Audio.
HTP-1 User Manual Page 79 V1.8.1
To Next Page
Loading...
