To Next PageTo Next Page
Need help?Do you have a question about the Montronix PulseNG Kit and is the answer not in the manual?
Verifies the compatibility of PulseNG-hmi with SINUMERIK systems.
Safety and caution guidelines for personnel and operations.
Defines roles for operation, setup, maintenance, and repairs.
Guidelines for safe operation with all safety equipment in place.
Identifies risks related to electrical parts and live wiring.
Physical dimensions of the IBU-NG interface module.
Warning regarding high-voltage areas during installation.
Details on connecting via LAN, USB, and serial interfaces.
Explains the meaning of the diagnostic LEDs on the IBU-NG.
Information on PulseNG sensor connection and dimensions.
Recommendations for mounting the PulseNG sensor securely.
Specifies recommended torque values for sensor mounting screws.
Guidelines for connecting and securing the PulseNG sensor cable.
Requirements for the 24V DC power supply for the PulseNG sensor.
Covers installation, software version checking, and basic usage.
Describes the initial window and soft key functions like Reset alarms and Teach.
Configuration options for data display views in PulseNG-hmi.
How to set and save operational limits.
Introduction to accessing and viewing event logs.
Displays event log entries in a text format.
Displays event log entries in a graphical format.
Functions for loading and saving graphics event logs.
Displays data processed by the Digital Signal Processor.
Shows the complete text event log entries.
How to export event log data in CSV format.
Settings for language, IP address, time synchronization, etc.
Customizing plot colors and display elements.
Mapping sensor axes to machine axes for analysis.
Configuring input/output contacts for the machine interface.
Accessing the operating manual and software information.
Selecting, naming, and configuring active scenarios.
Setting teach duration and number of teach cycles.
Configuring limit enablement, values, and alarm suppression.
Setting up filters, DSP scaling, and emergency stop for limits.
How to load previously saved scenario configurations.
How to save current scenario configurations.
Procedure to add new sensor IP addresses to the list.
How to modify or remove existing sensor entries.
Instructions for updating system software and firmware.
Resetting settings to factory defaults and system login.
Switching between statistics and raw data views.
General| Brand | Montronix |
|---|---|
| Model | PulseNG Kit |
| Category | Protection Device |
| Language | English |
