Montronix PulseNG Kit - Introduction; Product Certification

OPI-PulseNGKit-en-141106
Version: 2.01
Page 5 of 31
R
021,725,1*62/87,216
Operating Manual
PulseNG Kit
Introduction
The PulseNG Kit serves as permanently installed diagnostic tool for machines and
machining centers.
In principle, the PulseNG Kit consists of the PulseNG sensor and the interface
IBU-NG. For further details, please refer to the technical specications as listed in our
“BDS-PulseNGKit-en“.
The software provided as user interface for the PulseNG monitoring system is titled
PulseNG-hmi.
PulseNG-hmi runs under Microsoft Windows XP
®
, Windows 7 and Windows 8.
PulseNG-hmi provides process visualization for the different scenarios and serves to
check and set individual parameters and limits.
Valid up to Pu l seNG version 0.3.0 Build $Rev: 150$ R and Firmware version 013.
Product Certication
„This veries that PulseNG-hmi can be installed on and operated with SINUMERIK
840D sl with SINUMERIK Operate 4.5 SP3 on PCU 50 with Windows 7.“