OPI-PulseNGKit-en-141106
Version: 2.01
Page 7 of 31
021,725,1*62/87,216
Operating Manual
PulseNG Kit
Safety Instructions
Installation and service of the PulseNG sensor must only be performed by
trained professionals! Improper installation of the equipment may lead to
malfunction, equipment damage and could even cause bodily harm�
All safety instructions issued by the machine manufacturer must be observed�
When installing sensors, please make sure to secure suspended axes to
prevent them from falling!
• In addition to the operating manual, the user must observe the universally
accepted, legally and otherwise binding regulations governing accident prevention
and environmental protection, and must instruct others herein.
• The operating manual must be permanently available for reference at the location
of the system.
The operating manual must be read by any and all persons in charge of the following
tasks at the machine/machining center:
• All machine operations, including set-up, trouble-shooting during processing,
(preventive) maintenance, disposal of production waste, supplies, and additives
• maintenance (servicing, inspections, repairs) and/or
• transport
In addition to the operating manual, the operator is required to observe all accident
prevention regulations specic to the country and location where the system has been
installed, as well as generally recognized rules for safe and professional operations.
Organizational Measures
• Heed all safety and caution signs at the machining plant and building!
• Upon noticing changes to a machine‘s safety equipment or to its operations,
the machine/plant must be immediately stopped and any malfunction be
communicated to the person / authority in charge!
To Next Page
Loading...