49
VELOCITY OUT
The control signal available at this output is based on the Velocity of the notes
entered into the Arpeggiator or Sequencer with the keyboard.
CV OUTPUT: 0V to +5V (0V to +10V selectable via Global Settings)
CV OUT
The control voltage available at this output jack is the same used to specify
the pitch of the Oscillators being played by the Arpeggiator or Sequencer.
CV OUTPUT: -5V to +5V (0V to +10V selectable via Global Settings)
NOTE: The Arpeggiator and Sequencer can be disconnected from the Oscillators
in the Global Settings so that it can be patched independently from the keyboard.
GATE OUT
During Arpeggiator or Sequencer playback, a Gate signal will be produced
for the duration of each note, and available via this jack.
GATE OUTPUT: +5V (+10V selectable via Global Settings)
ARP / SEQ LHC CONTROLS
The Left-Hand Controller is where you will find additional
controls related to the Arpeggiator and Sequencer.
PLAY
The green PL AY button acts as a toggle to arm and disarm
the playback of the Arpeggiator or Sequencer. This button
will remain lit when the Sequencer or Arpeggiator is armed.
Press the notes to be arpeggiated, or the starting note of
the sequence to begin playback.
HOLD
The blue HOLD button acts as a latch for the Arpeggiator
or Sequencer. This button will remain lit as long as the Hold
function is engaged. When the HOLD button is engaged
(lit), the arpeggiated or sequenced pattern will continue to
play, even after your hand is lifted from the keyboard. In the
Arpeggiator mode, notes played while other notes are being
held on the keyboard will be added to an arpeggiated pattern.
Notes played after all fingers have been lifted from the
keyboard will begin a new pattern. In the Sequencer mode,
playing a note on the keyboard still specifies the root note,
or key, of the sequenced pattern.
ARP / SEQ (Continued)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
