Moore Industries STA - Installation in Hazardous Locations; Specific Conditions of Use

www.miinet.comMoore Industries-International, Inc.
- 19 -
User’s Manual
225-748-00P
August 2024
Programmable RTD, T/C, Ohms, mV and Potentiometer Safety Trip Alarm
STA
TPRG
SECTION 3
Installation in Hazardous Locations
This section contains important information regardin installation of the STZ in Hazardous Area
locations
Note:
The STA is suitable for Class I, Division 2, Groups A-D or General Locations only.
WARNING:
To prevent ignition of ammable or combustaible atmospheres, disconnect power berfore servicing.
AVERTISSEMENT:
Risque d’explosion. Avant de déconnecter l’equipement, couper le courant ou s’assurer que débrancher tant
que l’emplacement est désigné non dangereux.
Specific conditions of use
The following instructions must be adhered to when the STA is used in hazardous locations and
potentially expliove atmosphres.
The STA shall be installed in complaince with the enclosure, mounting, spacing, and segrgation
requirementsof the ultimate application.
cCSAus Installation
Nonincendive Applications
Class I, Division 2, Groups A-D
Electronic components must be mounted in a suitable enclosure.
s