www.miinet.comMoore Industries-International, Inc.
- 57 -
User’s Manual
225-748-00P
August 2024
Latching- By default, alarms will be unlatched. Select this to configured the STA with a latching
alarm, this alarm condition will not “clear” (the relay will not change state) until the input returns to
a non-alarm state AND manual reset terminals are shorted and then opened.
Input Fault Alarm Latching – By default, input fault alarms will be latched. Uncheck this box
to remove latching. When latching feature is on and the input goes into a Fault state the Fault
Alarm will remain engaged until you reset it via front panel, using the reset fault button in PC
Configuration Software, or by MR (if configured). When Latching is disabled the Fault Alarm will
disengage as soon as the Input returns to a Non-Fault State.
Manual Reset– This Feature allows you to select which alarms will reset when the Manual
Reset is engaged.
Note: Once you have configured all parameters, download to the unit by selecting “Download” in
the Transfer dropdown menu located in the Menu Bar. Or, click the button in the Menu Bar.
Programmable RTD, T/C, Ohms, mV and Potentiometer Safety Trip Alarm
STA
TPRG
SECTION 5
To Next Page
Loading...