Moore Industries STA - Page 69

www.miinet.comMoore Industries-International, Inc.
- 69 -
User’s Manual
225-748-00P
August 2024
Programmable RTD, T/C, Ohms, mV and Potentiometer Safety Trip Alarm
STA
TPRG
SECTION 7
Repair and Replacement
The STA is not intended to be repaired on site and has no components needing maintenance or
regular replacement. On device failure, the STA should be returned to Moore Industries Worldwide
Headquarters in North Hills, CA 91343 U.S.A for repair and refurbishment (refer to Returns
Procedures at the end of this manual).
The STA is a certied Safety component. Repair or replacement of any component without
authorization from Moore Industries International, Inc. will invalidate any remaining warranty and the
IEC61508 certication.
Recording and Reporting of STA Performance
It is the end user’s responsibility to maintain records of all safety component failures, especially those
that might be classied as potentially dangerous.
This feedback data not only helps the supplier identify and rectify reliability issues but also to provide
quantitative data to increase condence in the FMEDA analysis of dangerous failure rates. Please
ensure that any components returned to Moore Industries International, Inc. are returned with a clear
report identifying the fault experienced.