Operation
January 2019 5-17
Controller Options - Continued
Topcon - X35 Apollo - Continued
Lift Control Setup - Continued
Lift Control will work on both Virtual headlands and previous coverage, where the unit would normally turn off all
sections, will now auto lift and lower the drill.
Lift Control can be used to manually control the drill - Lift (Red Arrows) and Lower (Green Arrows).
Track Control is used to set whether the Lift Control will track the master state or not.
1. In ON state (Green) the drill position will follow master switch state.
• If the master is ON, the drill will be lowered, unless the drill is manually lifted.
• If the master is OFF, the drill will be lifted.
2. In OFF state (Red) the drill position is independent of master switch state.
Lift Control (Up / Down)
Over Ride
Drill Track Control
(Auto Lift)
To Next Page
Loading...
