Motorola solutions APX 6000XE - Manually Refreshing the Remote Emergency List; Receiving Remote Emergency; Sending an Emergency Alarm

3 To send Remote Emergency, press the PTT button.
If the ID of the target radio is valid, your radio displays sending notification and saves the ID as the last
Remote Emergency ID.
If the ID of the target radio is invalid, your radio displays an invalid ID notification.
If your radio is in one of the following states, your radio plays a tone.
• Receive-only Channel
• Transmit Inhibit
• Out of Range
• Imbalance Coverage
If your radio receives acknowledgment, your radio displays a positive notification.
If your radio does not receive acknowledgment from the target radio, your radio displays a negative
notification.
7.11.5.2
Manually Refreshing the Remote Emergency List
Procedure:
1 Press the programmed Remote Emergency button.
2 To refresh the remote emergency list, press Rfsh.
Your radio displays List refreshed followed by the updated remote emergency list..
7.11.5.3
Receiving Remote Emergency
The remote emergency will only be launched if your radio has the emergency enabled. The receiving
radio displays Emergency.
Procedure:
To exit the emergency operation, press and hold the programmed Emergency button.
7.11.6
Sending an Emergency Alarm
When and where to use: This feature allows you to send a data transmission, which identifies the
radio sending the emergency, to the dispatcher.
NOTE: The default timer of Emergency button press to activate Emergency is 50 milliseconds.
This timer is programmable from 50–6200 milliseconds by a qualified technician.
Procedure:
Press the preprogrammed Emergency button.
One of the following scenarios occurs:
• The display shows Emergency on the current zone and channel. You hear a short medium-
pitched tone and the LED blinks red momentarily.
68012003048-GW
Chapter 7 : Advanced Features
67