7.14
Tactical Public Safety (Conventional Only)
Tactical Public Safety (TPS) enables the member of a group to identify the start and the end of a
transmission by displaying the caller name or ID on the radio display.
7.14.1
Using TPS Normal Transmission
Procedure:
At TPS Zone Channel, perform one of the following actions:
• Press PTT button to transmit. Talk clearly into the microphone. Release PTT button to listen.
• Receive and listen to call, the radio displays the caller’s name or ID.
7.14.2
Using TPS Emergency Transmission
The following are two important alert tones designed for this feature.
Emergency Beacon
If you press the Emergency button during an emergency, the radio sounds a Beacon at maximum
volume using the radio internal speaker (not adjustable). When pressing the PTT button for voice
communication, the beacon is muted.
Emergency Call De-Key Sidetone
The radio sounds an alert tone to remind you that the Emergency Mode is still active after you
release the PTT button for an Emergency call transmission. The volume of loudness depends on
the maximum tone volume set in your radio profile.
Procedure:
1 Press the Emergency button to enter Emergency Mode.
The Emergency Beacon tone sounds.
2 Press PTT button to make an Emergency Call.
3 Release to listen.
The Emergency Call De-Key Sidetone sounds. After a short pause, the Emergency Beacon tone
sounds.
4 Press and hold the Emergency button to exit Emergency mode and cancel Emergency Beacon.
7.15
Man Down (Fall Alert)
Man Down (Fall Alert) is a supporting feature of the Emergency operation. The Emergency feature
must be programmed for Man Down (Fall Alert) to operate.
Your radio activates the Man Down (Fall Alert) feature when it achieves or exceeds a tilt angle
threshold or a combination of the angle threshold and radio motion below the motion sensitivity level.
68012003048-GW
Chapter 7 : Advanced Features
73
To Next Page
Loading...
Need help?
General
