The voltage threshold is customized in the external device
settings.
When the VIP switch turns on, the VIP asserts input to the
radio. The radio immediately initiates a 15 seconds of low
Voltage Pre-alert Timer. If the status of the VIP changed
before this time-out timer ends, the radio returns to normal
operation.
If the status from the VIP unchanged when the time-out
timer ends, the radio shows Low battery on the display
and also sounds low battery/voltage alert tone. The radio
sounds a short, high-pitched tone immediately after the
PTT button is released.
NOTICE:
If the mobile radio does not have a control head
connected, the bricks can only alert the user with
battery alert tone and the transmit chirp.
Next Button
If the O2 radio is programmed with this function, a
permanent softkey appears as the first softkey from the
right on the display. The softkeys appear at the bottom row
of the display.
NOTICE:
If the softkeys of the radio are configured less than
four softkeys, there shall be no Next button.
If there are more than four softkeys required on the radio,
the Next button helps to toggle to next screen for the
subsequent softkey(s) besides the first three softkeys.
Pressing this button shall toggle the screens until the last
softkey appears and then wraps back to the first four
softkeys.
Softkey without any function appears as blank.
NOTICE:
When a radio is set up with multi control heads
together with an O2 control head which were
configured with a Next button, the Next button is
also shown on the menus of other control heads.
Wi-Fi
You can connect your radio to a Wi-Fi network for wireless
programming.
NOTICE:
The Wi-Fi Network Name (SSID) for the radio to
connect to must be preprogrammed by a qualified
radio technician. Check with your dealer or system
administrator for more information.
English
164
To Next Page
Loading...
