Motorola APX 2500 - Front Panel Programming; Entering the Front Panel Programming Mode

Front Panel Programming
You are able to customize certain feature parameters in
Front Panel Programming (FPP) to enhance the use of
your radio.
Entering the Front Panel Programming
Mode
You can follow this procedure to enter the front panel
programming (FPP) mode on your radio.
Federal
1
Press
or to FPP and press the Menu Select
button directly below FPP.
The radio displays the Enter password screen.
2 Perform one of the following actions and proceed to
the next step:
• Press the Menu Select button directly below Ok.
• Enter the password and press the Menu Select
button directly below Ok.
If the password is not entered, the radio displays the
non-password protected zones only.
3
Press or to select Zn/Ch.
4 Press or to select the required zone.
5 Press or to select the required channel.
The display shows the radio parameter screen.
6 Press or to select the required parameter to
edit.
Non-Federal
1
Press
or to FPP and press the Menu Select
button directly below FPP.
The radio displays the Enter password screen
2 Enter the password and press the Menu Select
button directly below Ok.
3
Press or to select Zn/Ch.
English
182