Motorola APX 3000 Quick Reference Card

English
Sending an Emergency Call
To exit emergency at any time, press and hold
the Emergency button.
Sending an Emergency Alarm
To exit emergency at any time, press and hold
the Emergency button.
LED Indicator
Bluetooth Pairing with Mission Critical
Wireless Pod
You need to pair a Mission Critical Wireless
earpiece Bluetooth headset with Pod to your
radio to hear the Voice Announcement (feature
enabled via CPS).
Bluetooth Pairing with Key Fob
PMLN6233_ Discreet Mission Critical Wireless
RCU key fob is recommended to use with your
APX 3000 as it provides additional functionality
to this radio.
Connecting to Display RSM*
*Only Display RSM supports the APX 3000
display capability.
1 Press the Emergency button.
2 Press and hold the PTT button. Speak clearly
with the microphone near your mouth.
3 Release the PTT button to end call.
4 Press and hold Emergency button to exit
emergency.
1 Press the Emergency button.
2 The LED does not light up, and there is no
tone.
3 Silent emergency continues until you press
and hold the Emergency button to exit
emergency state.
OR
Press and release the PTT button to exit the
Silent Emergency Alarm mode and enter
regular dispatch or Emergency Call mode.
Solid red Radio is transmitting.
Blinking red
Radio is transmitting at low
battery condition.
Power-Up failure.
Solid green
Radio has completed power
up.
Blinking blue
(3 Blinks)
Bluetooth On/Off.
Blinking blue with
short interval
Bluetooth connection is idle
and ready to be paired.
Momentarily short
blinking blue
Bluetooth is connecting with
at least one device.
Very rapid blinking
blue
Bluetooth fails to connect or
disconnect from a device.
Solid blue for two
seconds
Bluetooth device is
connected or disconnected
successfully.
Solid blue Bluetooth error.
Blinking blue at
heartbeat pace
Radio is connected with at
least one Bluetooth
accessory device.
1 To function in Voice Announcement, plug the
earpiece into the Wireless Pod.
OR
To function as a Standalone PTT Device,
remove the earpiece.
2 Power on both your radio and Pod.
3 Ensure the Bluetooth feature of your radio and
Pod are enabled.
4 Place the Bluetooth pairing spot of your Pod
within one inch from the Bluetooth pairing spot
on your radio.
1 Verify that both your radio and your key fob
are powered ON and in pairing mode.
2 To enter pairing mode on your key fob, press
and hold the Trunk button while powering up
the key fob.
3 Place the Bluetooth pairing spot on your key
fob within one inch of the Bluetooth pairing
spot on your radio.
4 Radio LED repeats long blinking blue
indicating connection is successfully
established.
1 Turn off your Radio.
2 Align and attach the RSM’s connector to your
radio’s side connector.
3 Secure by tightening the screw on the lower
end of the connector.
APX_3000_M1.book Page 4 Wednesday, October 17, 2012 12:56 PM

Motorola APX 3000 Specifications

General

Brand	Motorola
Model	APX 3000
Category	Two-Way Radio
Language	English