Motorola CDM1550-LS+ - Sending a Call Alert Using the One-Touch Button

51
English
PASSPORT
SIGNALING
Sending a Call Alert using the One-Touch
Button
1 Press and hold the preprogrammed One-
touch button.
• The yellow LED indicator lights steady.
• The display shows F and the prepro-
grammed Alias or ID is displayed.
2 The Call Alert is sent automatically.
• The red LED indicator lights steady.
Note: Your radio sounds a continuous tone
(if preprogrammed by your dealer).
3 • While the Call Alert is being estab-
lished the F blinks and the red LED
indicator flashes momentarily.
• Once the Call Alert is established the
F displays solid.
Notes:
• If preprogrammed by your dealer, your
radio sounds a short high-pitched tone
(page established tone) to indicate
that the page was successful.
• If the Call Alert cannot be established,
you see:
for 5 seconds. The LED indicator turns
off.
• If all channels are busy while attempt-
ing a Call Alert,
you see:
and will hear a delayed busy tone as
long as the PTT button is pressed.
If the PTT button is kept pressed and
the system frees up a channel, the
radio automatically attempts to re-
establish the call.
• ( to end the Call Alert and revert to
talkgroup dispatch, or press the pre-
programmed Call Alert button. You can
then manually re-initiate the call. (See
Step 1.)
4 ( to end the Call Alert.
1R$FNQRZOHGJH
6\VWHP%XV\