31
English
GETTING STARTED
SENDING A CONVENTIONAL CALL
Note: In the United States, FCC regulations
require you to monitor the
conventional channels before sending
a call. The monitor feature (see
page 21) can be accessed through
one of your programmable buttons.
To send a conventional call:
RECEIVING A TRUNKED OR
CONVENTIONAL CALL
1 Hold the microphone in a vertical position
at a distance of about 1 to 2 inches
(2.5 to 5 cm) from your mouth.
2 Press the PTT button and speak clearly
into the microphone. The red LED
indicator lights steady while the call is
being sent.
3 Release the PTT button to listen.
1 Turn your radio on.
2 Adjust your radio’s volume (see
page 27).
3 v or w to select the desired trunked or
conventional zone, then y or z until
you see the desired preprogrammed talk-
group or conventional channel on the dis-
play.
• Make sure the PTT button is released.
4 Listen for voice activity. The red LED
indicator flashes when your radio is
receiving.
Note: The Mobile Identification Number
(XXXX) or Alias (if preprogrammed)
of the calling radio appears on the
display if Caller ID is enabled.
;;;;
To Next Page
Loading...
