Settings 9 - 5
2. Tap the Advanced tab.
3. Select the On battery power: Turn off device if not used for check box and select a value from the
drop-down list.
4. Select OK.
Backlight Settings
To change the backlight settings:
1. Tap > Settings > System > Backlight > Battery Power tab.
2. Select the Disable backlight if device is not used for check box and select a value from the drop-down
list.
3. Select the Brightness tab.
4. Tap the Backlight Auto Mode check box to disable auto mode.
5. Tap the Disable backlight check box to turn off the display backlight, or use the slider to set a low value
for the backlight.
6. Tap the Persist ‘Disable backlight’ setting over reset check box to enable the settings to persist after a
reset.
7. Tap OK.
Keypad Backlight Settings
To change the keypad backlight settings:
1. Tap > Settings > System > Keylight > Battery Power tab.
2. Select the Disable keylight if device if not used for check box and select a value from the drop-down
list.
3. Select the Advanced tab.
4. Tap the Keylight Auto Mode check box to disable auto mode.
5. Tap the Disable keylight check box to turn off the keypad backlight.
6. Tap the Persist ‘Disable keylight’ setting over reset check box to enable the settings to persist after a
reset.
7. Tap OK.
USB Configuration
The MC67 can be placed into any of the following USB modes:
•
USB Client - Sets the MC67 to USB Client mode.
•
USB Host - Sets the MC67 to USB Host mode.
To Next Page
Loading...
Need help?
General
