57
Private Call
Private Call
General
A Private Call, also called Point-to-Point or individual call, is a
call between two individuals. No other terminal can hear the
conversation.
This call can be a
• full-duplex call (if the system allows) in TMO, or
•a half-duplex call in TMO or DMO.
In a full-duplex call, both participants can speak at the same
time, while in a half-duplex call, only one person can speak at
a time.
For operating the MTM800 Enhanced in RF sensitive areas,
see “Transmit Inhibit” on page 41.
Making a Private Call in TMO
1. From the Home display dial a number.
2. If Private is not the first type of call
presented, press CType to select the
Private Call type.
3. For a half-duplex call, press and
release the PTT button. You will hear a
ringing tone. Wait for the called person to answer your call.
(This is also called a hook setup.) OR,
If your Service Provider has restricted access to the Contacts
list, it might not be possible to create a new contact, edit
existing contacts or dial up a number which is not in the
Contacts list.
While Transmit Inhibit is activated, an incoming Private Call is
indicated, but it is not possible to answer the call.
If you are in an on-going Group Call and wish to make a new
call, press to ignore the current call. Dial the number
.
Private #:
2234
Delete
CType
To Next Page
Loading...
