55
When the MTP850 Ex/MTP810 Ex detects
the proper repeater presence signal, the
Repeater icon will turn solid.
Selecting DMO Group Call via Gateway and Repeater
While in DMO, proceed as follows to choose the Gateway
and Repeater option to set up a call via Gateway or Repeater
(Gateway preferred) for the selected talkgroup.
1.
Press Optns, scroll to Config and press Select.
2.
Scroll to GW + Rep and press Select.
3.
The display shows the last “GW + Rep.” type
selection. Use the navigation key to scroll to
your selection and press Select:
Automatic
– the MTP850 Ex/MTP810 Ex
will use the first available gateway for that
talkgroup. The Gateway icon and the
repeater icon will flash upon selecting that option.
Specific
– the MTP850 Ex/MTP810 Ex will use only the
gateway with the specified Gateway address for that
talkgroup.
Upon selecting “Specific”, you will see one of the following
displays:
• The selected gateway address (e.g.:
1022), pre-programmed by your Service
Provider.
• “None”, indicating that no gateway was
selected for that talkgroup.
When the MTP850 Ex/MTP810 Ex detects
the appropriate gateway and/or the Repeater,
the Gateway and/or Repeater icons will turn
solid, respectively.
DMO Folder 1
Police
Hello
Optns Contcs
GW Options:
Specific
Automatic
Select Back
DMO Folder 1
Police
Hello
Optns Contcs
To Next Page
Loading...
