Standard Default Parameters A - 3
UID Parsing Disable
5-21
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type
IBM PC/AT& IBM PC Compatibles
1
6-4
Keyboard Wedge Country Types (Country Codes) North American
6-5
Ignore Unknown Characters Enable
6-7
Keystroke Delay 0 msec (No Delay)
6-7
Intra-Keystroke Delay Disable
6-8
Alternate Numeric Keypad Emulation Disable
6-8
Caps Lock On Disable
6-9
Caps Lock Override Disable
6-9
Convert Wedge Data Do Not Convert Wedge Data
6-10
Function Key Mapping Disable
6-10
FN1 Substitution Disable
6-11
Send Make and Break Send Make and Break Scan Codes
6-11
RS-232 Host Parameters
RS-232 Host Types
Standard RS-232
1
7-6
Baud Rate 9600
7-7
Parity None
7-9
Check Receive Errors Enable
7-10
Stop Bit Select 1 Stop Bit
7-11
Data Bits 8-Bit
7-11
Hardware Handshaking None
7-12
Software Handshaking None
7-14
Host Serial Response Time-out Minimum: 2 Sec
7-16
RTS Line State Host: Low RTS
7-17
Beep on <BEL> Disable
7-17
Intercharacter Delay Minimum: 0 msec
7-18
Nixdorf Mode A/B and OPOS/JPOS Beep/LED Options Normal Operation
7-19
Table A-1
Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
