Motorola SYMBOL DS6707 - Event Reporting; Decode Event

SSI Interface 5 - 15
Event Reporting
The host can request the digital imager scanner to provide certain information (events) relative to the digital imager
scanner’s behavior. Enable or disable the events listed in Table 5-2 and on the following pages by scanning the
appropriate bar codes.
Decode Event
Parameter # F0h, 00h
When enabled, the digital imager scanner generates a message to the host when it successfully decodes a bar
code. When disabled, no notification is sent.
Table 5-2 Event Codes
Event Class Event
Code
Reported
Decode Event Non parameter decode 0x01
Boot Up Event System power-up 0x03
Parameter Event Parameter entry error
Parameter stored
Defaults set (and parameter event is
enabled by default)
Number expected
0x07
0x08
0x0A
0x0F
Enable Decode Event
(01h)
*Disable Decode Event
(00h)