Motorola SYMBOL DS6707 - Appendix A Standard Default Parameters

Appendix A Standard Default Parameters
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults 4-4
Parameter Scanning ECh Enable 4-5
Beeper Tone 91h Medium 4-5
Beeper Volume 8Ch High 4-5
Suppress Power-up Beeps F1h D1h Do not suppress 4-6
Power Mode 80h Continuous On 4-7
Time Delay to Low Power Mode 92h 1 Minute 4-7
Trigger Mode 8Ah Auto Aim 4-9
Picklist Mode F0h, 92h Disabled Always 4-10
Presentation Mode Time Delay F1h, E9h Disable (3 Sec for Scanner with
Base)
4-11
Mobile Phone/Display Mode
F1h CCh Disable 4-13
Mobile Phone Decode Aggressiveness
F1h D6h F1h D6h 4-14
Decode Session Timeout 88h 9.9 Sec 4-15
Timeout Between Decodes, Same Symbol 89h 0.6 Sec 4-15
Beep After Good Decode 38h Enable 4-16
Decoding Illumination F0h, 2Ah Enable 4-16
1
User selection is required to configure this interface and this is the most common selection.