11 - 8 Symbol DS6707 Digital Imager Scanner Product Reference Guide
Special Commands
Pause Duration
This parameter, along with the Send Pause parameter on page 11-33, inserts a pause in the data transmission. Set
the pause by scanning a two-digit number (i.e., two bar codes) representing a 0.1 second interval in the range of
0.1 to 9.9. For example, scan bar codes 0 and 1 to insert a 0.1 second pause; 0 and 5 to insert a 0.5 second delay.
The default is 1 second. See Appendix D, Numeric Bar Codes. To correct an error or change a selection, scan
Cancel on page D-2.
Pause Duration
Begin New Rule
Scan the bar code below to start entering a new rule
.
Begin New Rule
Save Rule
Scan the bar code below to save the rule.
Save Rule
To Next Page
Loading...
