1 Place the charger on a flat surface.
2 Insert the connector of the Power Supply (1) into the
port on the side of the Drop-in Tray SUC (2).
3 Insert the radio into the charger with the radio facing
the front, as shown.
NOTICE:
When charging a battery attached to a radio, turn
the radio off to ensure a full charge. See
Operational Safety Guidelines on page 15 for more
information.
2.8
Charging a Stand-Alone Battery
To charge only the battery, perform the following steps:
English
Send Feedback 27
To Next Page
Loading...
Need help?
General
