ioLogik E1200 Series Using the Web Console
DO Safe Mode Settings
When a peer-to-peer rule on a local DO channel is not valid, or the peer-to-peer connection is down (e.g., the
Ethernet wire is unplugged or the device restarts), the local DO channel will enter Safe Mode. You can select
Hold Last, ON, or OFF from the Safe Mode Status dropdown menu for each DO channel. Once the DO
channel enters safe mode, the Safe Status will turn to ON. Click the Clear_Safe_Status button to change the
Safe Status back to NORMAL. Otherwise, it will remain in the ON position.
AO Safe Mode Settings
When a peer-to-peer rule on a local AO channel is not valid, or the peer-to-peer connection is down (e.g., the
Ethernet wire is unplugged or the device restarts), the local AO channel will enter Safe Mode. You can either set
the AO channel’s Safe Mode Value from 0–4095, or enable Hold Last Status during Safe Mode by selecting the
checkbox as shown in the following figure. Once the AO channel enters safe mode, the Safe Status will turn to
ON. Click the Clear_Safe_Status button to change the Safe Status back to NORMAL. Otherwise, it will
remain in the ON position.
SNMP
The ioLogik E1200 series remote I/O supports SNMPv1 and SNMPv2c for monitoring network I/O devices with
SNMP network management software, which is useful for building automation and telecommunications
applications.
SNMP Trap
The ioLogik E1200 series remote I/O provides standard SNMP traps and private SNMP traps for I/O devices.
To Next Page
Loading...
Need help?
General
