MGate 5105-MB-EIP Series User Manual
ATTENTION
If search by IP Address cannot locate the MGate 5000/MB3000/EIP3000 Series, the IP address you
entered might be incorrect. Try doing the search again and re-entering the IP address carefully.
Another possibility is that the MGate 5000/MB3000/EIP300 Series is on the same LAN as your PC, but on a
different subnet. Here, you can change your PC’s IP address and/or netmask so that it is on the same
subnet as the MGate 5000/MB3000/EIP300 Series. After your PC and the MGate 5000/MB3000/EIP300
Series are on the same subnet, MGate Manager should be able to find the unit.
Modifying the Configuration
Once your unit is displayed in MGate Manager, select it by clicking on it. The Configuration button will
become available. Click Configuration to open the configuration window.
Password Protection
For safety reasons, account/password protection is enabled by default so you must provide the correct
password to unlock the device before configuring the device.
The default password is moxa in all lowercase letters.
To Next Page
Loading...
