MGate 5105-MB-EIP Series User Manual
Append information
The Append Information will be included in the sent messages. For example,
“SiteName”:”Taipei 101”, “GPS_DMS”:”34°01'46.6"N 118°28'11.3"W”
I/O Data Mapping
The MGate provides an internal memory for data exchange between MQTT (Azure IoT Hub, MQTT JSON
Broker, MQTT Raw Broker, Alibaba Cloud IoT Platform) and fieldbus slave (EtherNet/IP, Modbus RTU/ASCII,
Modbus TCP) protocols. After finishing the protocol settings, go to the I/O Data Mapping page and check if
the data mapping is connected. Sometimes, you may need to switch to manual arrangement to adjust the
internal address for each command.by double-clicking on the name of the item. You may click on the Make
a proposal button for automatic arrangement.
Communication Analysis
After finishing all configurations, use Communication Analysis to confirm that the settings are correct.
Click Start and wait 10 seconds for the analysis report to appear and describe fail status details, warnings,
and hints.
To Next Page
Loading...
