Moxa Technologies MGate 5105-MB-EIP Series - Serial Settings

MGate 5105-MB-EIP Series User Manual
45
Serial Settings
The MGate 5105-MB-EIP’s serial interface supports RS-232, 2-wire RS-485, 4-wire RS-485, and RS-422
interfaces. You must configure baudrate, parity, data bits, and stop bits before using the serial interface
with Modbus RTS/ASCII protocol. Incorrect settings will cause communication failures.
Serial settings
Parameter
Value
Notes
Baudrate
Supports standard baudrates
(bps):
50/75/110/134/150/300/
600/1200/1800/2400/ 4800/
7200/9600/19200/38400/
57600/115200/ 230.4k/
460.8k/921.6k
Parity
None, Odd, Even, Mark,
Space
Data bits
8
Stop bits
1, 2
Flow control None, RTS/CTS, RTS Toggle
RTS Toggle will turn off RTS signals when there is no data
to be sent. If there is data to be sent, RTS will turn on
before data transmission and off after the transmission
completes.
FIFO Enable, Disable
The internal buffer of UART. Disabling FIFO can reduce the
latency time when receiving data from serial
communications, but this will also slow down the
throughput.
Interface
RS-232
RS-422
RS-485 2 wire
RS-485 4 wire
RTS on delay
0-100 ms
Only available for RTS Toggle
RTS off delay
0-100 ms
Only available for RTS Toggle