MGate 5105-MB-EIP Series User Manual
Common Settings
Refer to the appropriate reference section in Chapter 3: MGate Manager Configuration of this user’s
manual for each MGate Manager settings page.
MGate Manager Settings Page
Reference Section in Chapter 3
See Configure Device section
See Network Settings section
See Serial Settings section
Protocol Settings - Protocol Conversion
See Protocol Settings section
Protocol Settings - EtherNet/IP
See EtherNet/IP Settings section
Protocol Settings - Modbus RTU/ASCII
See Modbus RTU/ASCII Settings section
Protocol Settings - Modbus TCP
See Modbus TCP Settings section
System Management – Accessible IP List
See Accessible IP Settings section
System Management – System Log Settings
See System Log Settings section
System Management – Auto Warning Settings
See Auto Warning Settings section
System Management – E-mail Alert
See E-mail Alert Settings section
System Management – SNMP Trap
See SNMP Trap Settings section
System Management – SNMP Agent
See SNMP Agent Settings section
System Management – LLDP Settings
See LLDP Settings section
System Management – Misc. Settings
See Misc. Settings section
System Management – Maintenance - Firmware Upgrade
See Upgrade Firmware section
System Management – Maintenance - Configuration
Import/Export
See Import/Export section
System Management – Maintenance - Load Factory
Default
See Load Default section
In addition to the common settings above, the following functions mentioned in this chapter are only
available in the web console.
Protocol Settings
Protocol Settings – I/O Data Mapping
Here, you could click left on EtherNet/IP I/O connection. For example, click on O-> T Instance #100, which
will show what Modbus commands are included in the table on the right.
To Next Page
Loading...
