Moxa Technologies MGate 5105-MB-EIP Series - Page 62

MGate 5105-MB-EIP Series User Manual
62
LLDP Settings
Parameters
Description
Message transmit interval
Default is 30 seconds. The allowable range is between 5 and 32,768 seconds.
Misc. Settings
In order to support various security levels, console and sessions can be further configured.
Console Settings
Configuration
Value
Description
HTTP/HTTPS Enable/Disable
This setting is to enable/disable the web console. For security
issues, users can only enable the HTTPS or just disable all
settings.
Telnet/SSH
Enable/Disable
The MGate Telnet/SSH function can be enabled or disabled.
Serial Console
Enable/Disable
The MGate serial console function can be enabled or disabled.
Reset button
protect
Disable after 60 sec,
Always enable
The MGate provides the reset button to clear password or load
factory default settings. But for security issues, users can
disable this function. In disabled mode, the MGate will still
enable this function within 60 seconds after boot-up, just in
case users really need to reset this function.
Moxa command Enable/Disable
The MGate can be searched by the Device Search Utility (DSU).
If you have any security concerns, you can choose Disable to
deny the DSU right to access.
Session Settings
Value
Description
Maximum Login User
for HTTP + HTTPS
1-10
The number of users that can access the MGate at the same
time.
Auto Logout Setting
0-1440 min
Sets the auto logout time period