Moxa Technologies MGate 5105-MB-EIP Series - Ethernet;Ip Settings

MGate 5105-MB-EIP Series User Manual
47
ATTENTION
The MQTT protocol is not supported in MGate Manager yet. In order to apply MQTT protocol, please use
web console and follow the instruction in Chapter 2.
EtherNet/IP Settings
The MGate 5105-MB-EIP supports Adapter and Scanner modes for EtherNet/IP protocol. In Adapter mode,
you can select Automatic for I/O data size configuration to automatically map O->T (Originator to
Target) and T->O (Target to Originator) data sizes with Modbus data.
In Scanner mode, all EtherNet/IP connections will be shown in a table. For initial setup, click Add to create
a new connection.
Parameter
Value
Notes
EIP Encapsulation
Inactivity Timeout
0 to 3600, (0 for disable)
Unit: second
If there is no encapsulation activity for a specific time, the
Ethernet/IP session will be cleaned and the TCP connection
will be disconnected.
I/O data size
configuration
Automatic, User-defined
O->T (Output)
data size
0 to 496
Unit: byte
O->T: Originator to Target
T->O (Input)
data size
0 to 496
Unit:byte
T->O: Target to Originator