MGate 5105-MB-EIP Series User Manual
Mounting the Unit
1. Connect the power adapter. Connect the 12–48 VDC power line or DIN-rail power supply to the MGate
5105-MB-EIP device’s terminal block.
2. Use a Modbus serial cable to connect the MGate to a Modbus server/slave device.
3. Use an Ethernet cable to connect the MGate to the EtherNet/IP controller.
4. The MGate 5105-MB-EIP is designed to be attached to a DIN rail or mounted on a wall. For DIN-rail
mounting, push down the spring and properly attach it to the DIN rail until it “snaps” into place. For wall
mounting, install the wall-mount kit (optional) first, and then screw the device onto the wall. The
following figure illustrates the two mounting options:
Specifications
NOTE
The latest specifications for Moxa's products can be found at https://www.moxa.com.
Reset Button
Restore the MGate to factory default settings by using a pointed object (such as a straightened paper clip)
to hold the reset button down until the Ready LED stops blinking (approx. 5 seconds).
To Next Page
Loading...
