NPort 5600 Series User’s Manual NPort CE Driver for Windows CE
7-2
Overview
NPort CE Driver Manager is designed for use with NPort 5000 serial ports that are set to Real
COM mode. The software manages the installation of drivers that allow you to map unused COM
ports on your PC to serial ports on the NPort 5000. These drivers are designed for use with
Windows CE 5.0/6.0. When the drivers are installed and configured, devices that are attached to
serial ports on the NPort 5000 will be treated as if they were attached to your PC’s own COM
ports.
Installing NPort CE Driver Manager
1. Copy “NPortCab.cab” to Windows CE and start to install driver by double clicking on it.
2. Click on “OK” to complete the installation when the following screen appears.
3. Driver installation is now complete and the “NPortCab.cab” icon disappear from the screen.
This is normal when installing drivers in Windows CE.
Using NPort CE Driver Manager
After you install NPort CE Driver Manager, you can set up the NPort’s serial ports as remote
COM ports for your Windows CE. Make sure that the serial port(s) on your NPort are set to Real
COM mode when mapping COM ports with NPort CE Driver Manager.
To Next Page
Loading...
Need help?
General
