NPort 5600 Series User’s Manual Configuring NPort Administrator
6-21
Use the following procedure to map COM ports:
1. On-line COM Mapping:
Connect NPort to the network Set NPort to the proper IP address Map COMs to your
host Apply Change.
2. Off-line COM Mapping:
Map COMs to your host Apply Change Connect NPort to the network Configure
NPort’s IP address.
On-line COM Mapping
1. Broadcast Search for NPorts on the network.
2. Select the COM Mapping function group.
3. Add the target to which you would like to map COM ports.
4. The NPort list that appears is the list generated by the previous Broadcast Search. Select the
NPort to which you would like to map COM ports.
To Next Page
Loading...
Need help?
General
