NPort 5600 Series User’s Manual Web Console Configuration
5-31
RFC2217 Mode
TCP alive check time
Setting Factory Default Necessity
0 to 99 min 7 min Optional
0 min: TCP connection is not closed due to an idle TCP connection.
1 to 99 min: NPort 5600 automatically closes the TCP connection if there is no TCP activity for
the given time. After the connection is closed, NPort 5600 starts listening for another Real COM
driver connection from another host.
Packing length
Setting Factory Default Necessity
0 to 1024 0 Optional
Default = 0, The Delimiter Process will be followed, regardless of the length of the data packet. If
the data length (in bytes) matches the configured value, the data will be forced out. The data length
can be configured for 0 to 1024 bytes. Set to 0 if you do not need to limit the length.
Delimiter 1
Setting Factory Default Necessity
00 to FF (hex) None Optional
Delimiter 2
Setting Factory Default Necessity
00 to FF (hex) None Optional
Once the NPort 5600 receives both delimiters through its serial port, it immediately packs all data
currently in its buffer and sends it to the NPort 5600’s Ethernet port.
To Next Page
Loading...
Need help?
General
