PT-7728 User’s Manual Featured Functions
3-28
Coupling Control Port
Setting Description Factory Default
Coupling Control Port
This specifies which port on the PT-7728
will be used as the coupling control port.
Port 1-4 (without
Gigabit Ethernet
module)
Port 4-2 (with Gigabit
Ethernet module)
Configuring Turbo Ring V2
NOTE
When using a dual-ring architecture, users must complete configuration for both Ring 1 and Ring
2. The status of both rings will appear under Current Status.
"Current Status" Items
Now Active
This shows which communication protocol is in use: Turbo Ring, Turbo Ring V2, Turbo Chain,
RSTP, or none.
Ring 1/2—Status
This shows Healthy if the ring is operating normally, and shows Break if the ring’s backup link is
active.
Ring 1/2—Master/Slave
This indicates whether or not the PT-7728 is the master of the Turbo Ring. This field appears only
when selected to operate in Turbo Ring or Turbo Ring V2 mode.
To Next Page
Loading...
Need help?
General
