Operation
ALTAIR 4X
36
GB
Setup Time and Date
This submenu is for setting date and time.
For more information, see the flow charts in [ chapter 8.10].
Fig. 7 Date and Time Setup
(1) To bypass this setup, press the or button; otherwise, continue as follows.
(2) Press the ON/OFF button to enter the submenu.
(3) Set month by pressing the or button.
(4) Press the ON/OFF button to confirm month.
(5) Repeat this procedure for day, year, hours and minutes.
By default, time is displayed in 12 hour format.
The EXIT screen will be displayed next.
(6) Confirming this screen with the ON/OFF button exits the device setup.
If the sensors have not warmed up yet, the countdown is displayed.
The device then goes to Measuring mode.
3.5 Data Logging
Connecting device to PC
(1) Switch on the device and align the Datalink Communication port on the device
to the IR interface of the PC.
(2) Use the MSA Link software to communicate with the device.
See MSA Link documentation for detailed instructions.
FASIT Srl - Via Orsera 13/b - 34145 TRIESTE - ITALY - Tel +39 040 825604 - www.fasit.it
- info@fasit.it
To Next Page
Loading...
