MSA General Monitors OBSERVER-i - Command #166: Get Device Firmware Revision; Command #169: Load Factory Default Setting

OBSERVER-i HART
24
10.21 COMMAND #166: GET DEVICE FIRMWARE REVISION
This command reads the Observer-i firmware revision.
Request Data Bytes
Byte
Format
Description
None
N/A
N/A
Response Data Bytes
Byte
Format
Description
0
Unsigned-8
System Firmware Revision. ASCII code
Command-Specific Response Codes
Code
Class
Description
0
Success
No Command-Specific Errors
1-127
Undefined
10.22 COMMAND #169: LOAD FACTORY DEFAULT SETTING
This command will load the factory default settings.
Request Data Bytes
Byte
Format
Description
0
N/A
N/A
Response Data Bytes
Byte
Format
Description
0
N/A
N/A
Command-Specific Response Codes
Code
Class
Description
0
Success
No Command-Specific Errors
1- 2
Undefined
3
Error
Parameter too Large
4
Error
Parameter too Small
5 - 15
Undefined
16
Error
Access Restricted
17 - 127
Undefined