MSA General Monitors OBSERVER-i - Tables; OBSERVER-I DEVICE SPECIFIC COMMANDS SUMMARY; Table 5: Observer-I Device Specific Commands

OBSERVER-i HART
29
11.0 TABLES
11.1 OBSERVER-i DEVICE SPECIFIC COMMANDS SUMMARY
The following Table 5 is a summary of the Observer-i Device Specific Commands.
Command
Number
Meaning
132
Do Alarm Test
136
Set Alarm Level
139
Reset Alarms
141
Set Relay State
142
Reset Event Happening Flag
143
Read Event Logging Counters
144
Clear Event Logging Counters
146
Read Alarm Event Log
147
Read Fault Event Log
148
Read Maintenance Log
149
Set Time Clock
150
Read Time Clock
151
Set Running Time
152
Read Running Time
154
Set Event Index
155
Read Event Index
156
Read Calibrate Event Log
163
Get Fast Changing Information
164
Get Slow Changing Information
165
Get setup Information
166
Get Device Firmware Revision
169
Load Default Setting
170
Set Current Range
171
Set Detection Mode
172
Set Enhance Ao Mode
192
Do Calibration
195
Do Acoustic Test
201
Set Alarm Delay Time
Table 5: Observer-i Device Specific Commands