MTD Cub Cadet 221 HP User Manual

Auger, Belt and Pulleys
25
7. Gently pry the bearing (indicated by the arrow in Fig-
ure 3.20.) out of the auger housing.
8. Install the auger bearing by following the previous
steps in reverse order.
NOTE: Tighten the bearing retainer screws to a torque of
70 - 100 in lbs (8 - 11 Nm).
9. Test run the snow thrower in a safe area before
returning it to service.
Figure 3.20

MTD Cub Cadet 221 HP Specifications

General

Brand	MTD
Model	Cub Cadet 221 HP
Category	Snow Blower
Language	English