43 MTS_OW100_IFU-orthogold100-US-K182682_A
Danger of infection
The applicator must never get in direct contact with skin injuries or
abscesses. Otherwise infectious material can contaminate the
water membrane/ applicator or the water membrane can
contaminate the wound.
4.1 Setting the Output Parameters
Operation with the Touch Panel
To adjust the treatment parameters, you can use the touch panel or the touch wheel. To
change a value, touch one of the arrows (2, 4) or drive the bar (3) with your finger to the
desired value. Push and hold leads to the so-called auto-repeater-function. That means, that
the value starts and runs until you remove your finger from the key field. A short push however
alters the accordant value about one step at a time.
Using the key field “Reset” you can reset the shot counter (6) to zero. Push this key
field before you start a treatment.
Using the key field "Setup”, you will get to the setup menu. This second menu offers
device related and individual settings.
Using the key field "FILL”, you fill the applicator with water. Pushing the key field
“DRAIN” drains the applicator.
To Next Page
Loading...
Need help?
General
