MTS Systems Ultimate TV - Reset the Remote

To Next Page

To Previous Page

NOTE: If a programmed mode key has no volume commands of its own, then the volume control will normally

operate the TV. If an invalid key is pressed, the selected mode key light ﬂ ashes for 3 seconds and turns oﬀ . The

remote control returns to normal operation and you will need to start over.

If no key is pressed within 30 seconds, the remote control times out, the selected mode key light ﬂ ashes for 3

seconds and turns oﬀ . The remote control returns to normal operation at which time you can start over.

Black MXv4 (RF) with MTS logo remote:

To cancel Volume Control Lock to a single device:

1. Press and hold SETUP until the mode key blinks twice

2. Press the MUTE key

3. The mode key (TV, DVD, or AUX) will blink 4 times upon successful unlock

Reset the remote

To restore the factory default settings

Silver/charcoal remote:

1. Press and hold the STB/MTS key and hold the OK key simultaneously on the remote control

2. Release both the STB/MTS key and the OK key – all four mode keys will ﬂ ash twice indicating programming

mode

3. Enter programming code 900 by pressing the number keys on the remote control – the STB/MTS key will ﬂ ash

three times indicating you have successfully entered the code and the remote has been reset to the factory

default settings

Note: If any other key is pressed except the number keys the STB/MTS key will give a long red ﬂ ash and the

remote control will return to normal operation. Should the remote control time-out before you complete the

procedure you will need to start over.

Black MXv3 (RF) remote:

1. Press the TV key and while holding it pressed, press the OK key for 1 second and release both keys at the same

time

2. All the mode keys will ﬂ ash and the TV mode key light will stay on

3. Press and hold the DELETE key for 3 seconds until the TV mode key blinks and stays oﬀ . The remote control is

now reset to factory default settings. If you want to use the remote control for your TV and other devices, you will

need to setup the TV, DVD, and AUX mode keys

4. If no key is pressed within 30 seconds, the remote control times out. The selected mode key light ﬂ ashes for 3

seconds and turns oﬀ . The remote control returns to normal operation and you will need to start over

Black MXv4 (RF) with MTS logo remote:

1. Press and hold SETUP until the LED blinks twice

2. Press 981 on the number pad and the LED will blink 4 times

3. The mode key (TV, DVD, or AUX) will blink 4 times upon successful unlock