Abbre‐
viation
Meaning Explanation
EMU Engine Monitoring Unit
ETK Ersatzteilkatalog Spare Parts Catalog (SPC)
EUI Electronic Unit Injector
FPS Fuel Pressure Sensor
FRS Fuel Differential Pressure Sensor
FTS Fuel Temperature Sensor
FWCP Fire Water Control Panel
GND Ground
HP High pressure
HI High Alarm: Measured value exceeds 1st maximum limit
HIHI High High Alarm: Measured value exceeds 2nd maximum
limit value
HT High Temperature
IDM Interface Data Module Memory module for interface data
INJ Injector
ISO International Organization for Standardi‐
zation
International umbrella organization for all national
standardization institutes
KGS Kraftgegenseite Engine free end in accordance with DIN ISO 1204
KS Kraftseite Engine driving end in accordance with DIN ISO
1204
LED Light Emitting Diode
LO Low Alarm: Measured value lower than 1st minimum
limit value
LOLO Low Low Alarm: Measured value lower than 2nd minimum
limit value
LSG Limiting Speed Governor
N/A Not Applicable
LP Low pressure
OEM Original Equipment Manufacturer
OI Optimized Idle
OLS Oil Level Sensor
OPS Oil pressure sensor
OTS Oil Temperature Sensor
OT Oberer Totpunkt Top dead center (TDC)
PAN Panel Control panel
PIM Peripheral Interface Module
PWM Modulated signal
P-xyz Pressure-xyz Pressure measuring point, xyz specifies the meas‐
uring point designation
RL Redundancy Lost Alarm: Redundant CAN bus failure
SAE Society of Automotive Engineers U.S. standardization organization
SD Sensor Defect Alarm: Sensor failure
MS150049/02E 2012-11 | Appendix A | 145
TIM-ID: 0000000858 - 010
To Next Page
Loading...
