56 Part Number: WBL-95-156 REV002
Maintenance Section 4
Auto Prime
1. Remove the hose from the shaker jug
NOTE: Top off the spray bottle with sanitizing solution from jug.
2. Disconnect the hose from CIP Pump Connector.
3. Do NOT remove bottomless cleaning cup.
4. Press Confirm button to proceed to Auto Prime the
lines with product.
AUTO PRIME
The screen will display Auto Prime progress for each line
until all lines have been primed.
Auto Prime Complete
1. Remove bottomless cleaning cup from shuttle.
1.
Remove Splash Guard & Shuttle
1. Manually move shuttle all the way to the blend area on
the right.
2. Tilt top of shuttle forward towards front of unit past
blender cap to remove.
3. Grasp rail, shift to the left, and lift right edge to clear tab.
4. Shift rail slightly towards the right to clear left tab and
lift out to remove.
5. Unlatch and remove blending chamber splash guard
from top door.
6. Press Next when ready to continue.
Clean & Sanitize Blender Splash Guard and Shuttle
Important
DO NOT put the shuttle or rail in dishwasher or power soaker.
DO NOT use abrasive cleaners or pads on the clear splash
guard, this will scratch and damage the guard.
1. Take the blender splash guard, shuttle, and rail to the kitchen.
2. Wash, rinse, and sanitize the splash guard, shuttle, and rail
in the three compartment sink making sure to remove any
product residue.
3. Allow all pieces to air dry.
4. Press Next when ready to continue.
To Next Page
Loading...
