Multitech MultiConnect - Page 31

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 31
Serial Commands – Setup
Command Syntax set serial [s0] auto-dialin trig-mode <char/ dtr/ dtr-char/ none>
Description This mode is applicable only when auto dial-in is enabled on the serial port
S0. This command is valid only for device port S0.
Parameter Description
char
Initiate a session (Telnet) to the auto-dialin-ipaddress, only on a reception
of a character on the serial port S0.
dtr
Initiate a session (Telnet) to the auto-dialin-ipaddress, only on seeing a
DTR signal on the serial port S0
dtr-char
Initiate a session (Telnet) to the auto-dialin-ipaddress, either on reception
of a character (OR) seeing the DTR signal on the serial port S0.
none
Initiate a Telnet session to the auto-dialin-ipaddress on module boot-up.
Default Value
dtr-char
Success
OK
Error 1. Too few arguments
Too few arguments. Possible argument(s) are
char dtr-char
dtr none
2. Invalid string
“Invalid string "string"
Valid arguments are
char dtr-char
dtr none
3. If “set serial s1 auto-dialin trig-mode <char/dtr/dtr-char/none>” is given
“error: Command not supported on modem port s1”
Command Syntax set serial [s0] auto-dialout <enable/disable>
Description
Enables/disables connectivity to the serial device from the IP-enabled built-
in modem serial interface. This command is valid only for device port S0.
Default Value
Enabled
Success
OK
Error 1. Too few arguments
“Usage: set serial s0 auto-dialout <enable/disable>
Type ‘set serial s0 auto-dialout ?’ for more information”
2. Multiple matches
auto-dialin auto-dialin-protocol auto-dialout-protocol
auto-dialin-ipaddress auto-dialout
auto-dialin-port auto-dialout-port
3. Invalid string
error: Invalid string
Type ‘set serial s0 auto-dialout ?’ for more information”
4. If “set serial s1 auto-dialout <enable/disable>” is given
“error: Command not supported on modem port s1”