Multitech MultiConnect - Page 45

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 45
PPP Commands – Show
Command Syntax show ppp ppp0 configuration
Description
Displays:
PPP Status (enabled/disabled)
Authentication status
Authentication type
Username and password for authentication
Compression status
Compression type
IPCP Mode
Local IP Address
Remote IP Address
Default Value
NA
Success
OK
Error
1. Too few arguments
Possible argument(s) are
configuration ip-addr
statistics link-status
2. Invalid argument
Invalid argument
Valid argument(s) are
configuration ip-addr
statistics link-status
Command Syntax show ppp <interface> ip-addr
Description
Displays:
Local IP Address
Remote IP Address
Default Value
NA
Success
OK
Error
1. Too few arguments
Possible argument(s) are
configuration ip-addr
statistics link-status
2. Invalid argument
Invalid argument
Valid argument(s) are
configuration ip-addr
statistics link-status
Command Syntax
show ppp <interface> link-status
Description
Displays the link status on ppp interface.
Default Value
-
Success
OK
Up / Down
Error
1. Too few arguments
Possible argument(s) are
configuration ip-addr
statistics link-status
2. Invalid argument
Invalid argument
Valid argument(s) are
configuration ip-addr
statistics link-status