Multitech MultiConnect - Page 59

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 59
SNTP Client Commands – Setup
Command Syntax set sntp-client daylight-saving start-weekday <dayofweek>
where
dayofweek = sunday, monday ... Saturday
Description
Sets the start weekday to use during the Day Light Saving Mode.
Default Value
Sunday
Success
OK
Error 1. Invalid arguments
"error: Invalid start day of the week"
2. Too few arguments
“Usage: set sntp-client daylight-saving start-weekday <dayofweek>
Type set sntp-client daylight-saving start-weekday ? for more
information”
Command Syntax set sntp-client daylight-saving start-month <month>
where
month = january, february .... December
Description
Sets the start month to use during the Day Light Saving Mode.
Default Value
April
Success
OK
Error 1. Invalid arguments
"error: Invalid start month"
2. Too few arguments
“Usage: set sntp-client daylight-saving start-month <month>
Type set sntp-client daylight-saving start-month ? for more information”
Command Syntax set sntp-client daylight-saving start-time <hh:mm>
where
hh = 00 to 23
mm = 00 to 59
Description
Sets the start time to use during the Day Light Saving Mode.
Default Value
02:00
Success
OK
Error 1. Invalid arguments
"error: Invalid start time"
2. Too few arguments
“Usage: set sntp-client daylight-saving start-time <hh:mm>
Type set sntp-client daylight-saving start-time ? for more information”
Command Syntax set sntp-client daylight-saving end-ordinal <string>
where
string = first/second/third/forth/last
Description
Sets the end ordinal to use during the Day Light Saving Mode.
Default Value
Last
Success
OK
Error 1. Invalid arguments
"error: Invalid end ordinal"
2. Too few arguments
“Usage: set sntp-client daylight-saving end-ordinal <string>
Type set sntp-client daylight-saving end-ordinal ? for more information”