multivac P200 - Page 37

Start-up
Setting up the machine and putting it into operation
03.06.2014 37
¾ Unscrew the screw plug. To do so, turn the screw plug anti-
clockwise.
¾ Only drain so much oil until the oil level is roughly in the middle
of the oil sight glass.
¾ Screw the screw plug tightly in the drain opening. To do so,
turn the screw plug clockwise.
¾ Wipe off and remove any oil from the machine.
¾ Check the oil level on the oil sight glass.
¾ Turn the screw plug in the fill opening and screw it tight. Turn the
screw plug clockwise.
¾ Wipe off and remove any oil